Home
India's Premium Wood Presservation Oil
About Wood Shell
Contact Us
Feedback Form
Lada Organics Pvt. Ltd.
Works
 
S. No. 43, Dattanagar, Jambhulwadi
Road, Ambegaon (BK),
Pune - 411046. (M.S. India)
Tel. No. :+91-20 - 24318430, 24317211.
Fax : +91-20 - 24318430.
Contact Person : Mr. J. T. Das - Dir.
Mobile : +91-20 - 94220 31808
E-mail : ladagroup@rediffmail.com
...........................................................
Registered Office
 

A-41, Sawant Vihar, Second Floor,
Near Katraj Dairy, Pune - 411046,
(M.S. India)

"Wood Preservation & Timber Preservation Oil / Wood Tonic"
 
 
  What is Wood Preservative
   
  Wood Preservative Oil
   
 
 
  Contents
Petrochemical Derivatives, Carbolic Acid, Naphthalene Compounds,   Oil base etc
  Appearance   
Brown semi-transparent oil. Specific Gravity 0.89. Pungent Phenolic   Odour.
  Uses
Use exclusively for Wood Preservation only. Not for Consumption.
  Application
May be used for and applied effectively to: Plywood, Ply-Board, Teak,   Shisam, Rose Wood ..................... quite literally, apply to any type   of wood
  Penetration   
Penetrates up to 4/5 mm deep into Plywood, Plyboard, Okal board   and other low density hot/cold pressed wood and up to 3 mm into   teak, Shisam and Rose wood.
  Coverage
Approximately 150 sq.feet to a litre - Single coat.
  Development

Continuous development in our Modern plant, with the latest     technology and Modern Management techniques, to give you the Best   at the lowest price.

  Precautions

Avoid direct skin contact. Please use gloves when using the product.   Wash hands with soap and water after use. If liquid gets into the   eyes, flush eyes under running water and consult your doctor   immediately.

  Attention

  Never, never dilute the product with anything. Use full strength,   straight from the pack on to the wood, for the best results.

  Method of Use

  In case of new wood/plywood, clean the area to be applied, with a   moist cloth and apply liberally with a dry brush, evenly, into the   grains. Aliow to dry for at least 8-10 hours and appfy second coat, if   necessary. Paint, Polish or Laminate as desired. In case of infected   wood, check for severity of infection and apply as described above. If   pin holes are apparent, inject into the holes with a small syringe to   the point of rejection. Seal the injected holes with putty or adhesive   and thereafter, finish as desired. In case of very severe infection,   consult the for further remedies.

  Preventive, Preservative and Curative to keep your wood, the way it should be!
   
 
 
 
...............................................................................................................................